Artesion
Pro Series Pumps
Oregon
UPS
Ground
-
MUST
be plugged in to a properly grounded and GFCI (Ground Fault Circuit Interrupter)
protected 120 Volt outlet !
-
Pumps
supplied without power cord must be hard-wired to a GFCI-protected circuit
by a licenced electrician
-
Not
for use in swimming pools or salt water
-
DO
NOT SUBMERSE !
|
|
PerformancePro
Artesian Pro is the pump you need for your higher flow applications. It
not only delivers great flow rates at useable heads, but it does so efficiently!
You get the safety and convenience of self-priming along with great energy
savings. For ease of use, it provides a large strainer basket, and an easy
open Lexan lid. The
specially
designed lid and clamp ring insure a positive seal with very little o-ring
wear.
Available
in 1/4 to 1 HP @ 1,725 low RPM models and 1/2 to 3 HP @ 3,450 high RPM
models.
-
Money-saving
high efficiency pump and motor units
-
Designed
to operate anywhere on their performance curve
-
Minimum
recommended continuous flow rate is one gallon per minute
-
3"
suction and discharge ports with quick disconnect unions
-
2"
or 3" tail pieces are available for easy attachment (Note: 3" reverses
to fit 2-1/2" pipe)
-
Long-life
corrosion resistant 316 stainless steel shaft seals
-
Impeller
interchangeability allows you to easily change your pump’s performance
-
Top-of-the-line
US motors
-
All
1,725 RPM motors are totally enclosed for extra protection and long life
-
Both
pump end and motors are designed for quiet operation
-
A 16
AWG, 8 ft. cord with 115 V plug is optional (1,725 RPM models, 1/4 HP to
1/2 HP - please order below)
-
A 12
AWG, 8 ft. cord with 115 V plug is optional (1,725 RPM models, 3/4 HP to
1 HP and 3,450 RPM models, 1/2 HP to 1 HP - please
order below)
-
Saltwater
kits are available - please order below
-
Safety
first - out of the pond pumps help protect both you and your fish from
annoying and potentially dangerous oil or electrical leaks
-
3-year
manufacturer's limited warranty
Pump Placement
When determining the placement
of your Artesian pump, two factors will be influenced by its height above
water level. First is its ability to prime. To insure a reasonable prime
time, position the pump no higher than the height shown in the "Maximum
Recommended Suction Lift" column. Second is its ability to operate without
cavitation. To avoid cavitation, position the pump no higher than the height
shown in the "Maximum Suggested Operating Height" column.
Performance
Curves - Low RPM Pumps
Performance
Curves - High Flow Pumps
Performance
Curves - High Head Pumps
To view these files you need Adobe Acrobat Reader 4.0 or higher. If you
do not already have Adobe Acrobat Reader installed on your computer, please
click on the Adobe logo to download it free of charge.
|
...
...
